FRONT DOOR COURTESY SWITCH(for Sedan) INSTALLATION

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

    1. Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.

      6.3 N*m

      64 kgf*cm

      56 in.*lbf

      Tip:

      There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

    2. Connect the connector.

  2. INSTALL CENTER PILLAR LOWER GARNISH

  3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

  5. INSTALL FRONT DOOR SCUFF PLATE

  6. INSTALL REAR DOOR SCUFF PLATE