CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM(for 8NR-FTS), Diagnostic DTC:P056014
| DTC Code | DTC Name |
|---|---|
| P056014 | System Voltage Circuit Short to Ground or Open |
DESCRIPTION
The battery supplies electricity to the ECM even when the ignition switch is off. This power allows the ECM to store data such as DTC history, freeze frame data and fuel trim values. If the battery voltage falls below a minimum level, the memory is cleared and the ECM determines that there is a malfunction in the power supply circuit. The next time the engine is started, the ECM will illuminate the MIL and store this DTC.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
Memory |
Note |
|---|---|---|---|---|---|---|
P056014 |
System Voltage Circuit Short to Ground or Open |
1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
Comes on |
DTC stored |
SAE Code: P0562 |
If DTC P056014 is stored, the ECM will not store other DTCs or the data stored in the ECM will be partially cleared.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Inspect the fuses for circuits related to this system before performing the following procedure.
After turning ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
-
Turn the ignition switch to ON and wait for 3 seconds or more.
Check for DTCs again.
PROCEDURE
INSPECT BATTERY
Inspect the battery.
OK
Battery voltage is between 11 and 14 V.
Result
Proceed to
OK
NG
NG CHARGE OR REPLACE BATTERY
CHECK BATTERY TERMINAL
Check that the battery terminals are not loose or corroded.
OK
Battery terminals are not loose or corroded.
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE BATTERY TERMINAL
CHECK HARNESS AND CONNECTOR (POWER SOURCE OF ECM)
Disconnect the A173 ECM connector.
Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection
Condition
Specified Condition
A173-1 (BATT) - Body ground
Always
11 to 14 V
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR (BATTERY - ECM)
CHECK WHETHER DTC OUTPUT RECURS (DTC P056014)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Clear the DTCs.
Powertrain > Transmission > Clear DTCs
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the GTS on.
Wait for 3 seconds or more.
Enter the following menus: Powertrain / Transmission / Trouble Codes.
Read the DTCs.
Powertrain > Transmission > Trouble Codes
Result
Result
Proceed to
DTC P056014 is output
A
DTCs are not output
B
REPLACE ECM
Replace the ECM.
Result
Proceed to
NEXT