FUEL INJECTOR INSTALLATION

PROCEDURE

  1. INSTALL FUEL INJECTOR ASSEMBLY

    Tip:

    Perform "Inspection After Repair" after replacing the fuel injector assembly.

    Click hereClick here

    1. A153011C05

      *1

      O-ring

      *2

      Injector Vibration Insulator

      Apply a light coat of gasoline or spindle oil to new injector vibration insulators and O-rings, and then install one onto each fuel injector assembly.

    2. Apply a light coat of gasoline or spindle oil to the contact surfaces of a new O-ring on each fuel injector assembly.

    3. A173350

      While turning the fuel injector assembly left and right, install it onto the fuel delivery pipe sub-assembly.

      Note:
      • Do not damage the fuel injector assembly or O-ring.

      • Do not twist the O-ring.

      • After installing each fuel injector assembly, check that it turns smoothly. If not, replace the O-ring with a new one.

  2. INSTALL NO. 1 DELIVERY PIPE SPACER

    1. A153008C01

      *a

      Fuel Delivery Pipe Sub-assembly Side

      *b

      Cylinder Head Side

      Install the 2 No. 1 delivery pipe spacers onto the cylinder head.

      Note:

      Install the No. 1 delivery pipe spacers in the correct direction.

  3. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY

    1. Install the fuel delivery pipe sub-assembly with the 4 fuel injector assemblies and install the 2 bolts.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

      Note:
      • Do not drop the fuel injector assemblies when installing the fuel delivery pipe sub-assembly.

      • After installing the fuel delivery pipe sub-assembly, check that the fuel injector assemblies turn smoothly.

    2. Install the bolt to secure the fuel delivery pipe sub-assembly.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

    3. Install the wire harness clamp bracket with the bolt.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

  4. CONNECT FUEL TUBE SUB-ASSEMBLY

    1. A149876C04

      *1

      Fuel Delivery Pipe Sub-assembly

      *a

      Retainer

      *b

      O-ring

      Connect the fuel tube sub-assembly connector to the fuel delivery pipe sub-assembly until a "click" sound is heard.

      Note:
      • Check that there are no scratches or foreign matter on the contact surfaces of the fuel tube sub-assembly connector and fuel delivery pipe sub-assembly before performing this work.

      • After connecting the fuel lines, check that the fuel tube sub-assembly connector and fuel delivery pipe sub-assembly are securely connected by pulling on them.

    2. A294334

      Install a new No. 2 fuel pipe clamp (Type A).

    3. A294335C01

      *a

      Claw

      Install a new No. 2 fuel pipe clamp (Type B).

  5. INSTALL WIRE HARNESS CLAMP BRACKET

    1. A205213

      Install the wire harness clamp bracket with the 2 nuts.

      18 N*m

      183 kgf*cm

      13 ft.*lbf

  6. INSTALL AIR TUBE

  7. CONNECT ENGINE WIRE

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  9. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

  10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  11. INSPECT FOR FUEL LEAK

  12. INSTALL NO. 2 CYLINDER HEAD COVER