REAR BRAKE FLEXIBLE HOSE(for Double Wishbone Type Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Note:
  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the rear flexible hoses.

  • If the rear flexible hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tip:
  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. INSTALL REAR FLEXIBLE HOSE

    Note:

    When installing the rear flexible hose, minimize twisting of the hose.

    1. Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      29 N*m

      296 kgf*cm

      21 ft.*lbf

      Note:

      Install the rear flexible hose lock securely into the lock hole in the rear disc brake cylinder assembly.

    2. Install the bolt.

      29 N*m

      296 kgf*cm

      21 ft.*lbf

    3. Install a new clip.

      Note:

      Install the clip as far as it will go.

    4. Using a union nut wrench, connect the brake tube to the rear flexible hose while holding the rear flexible hose with a wrench.

      15.2 N*m

      155 kgf*cm

      11 ft.*lbf

      Note:
      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt or dust to enter the brake tube from the connecting parts.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

        Click hereClick hereClick hereClick here

  2. BLEED BRAKE LINE

  3. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf