ECM(w/ Glow Plug Controller) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:
    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

      Click hereClick here

    • If the ECM has been struck or dropped, replace it.

    • Perform the Vehicle Identification Number (VIN) registration when replacing the ECM.

      Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

  4. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  6. SEPARATE NO. 1 AIR CLEANER INLET

    1. A345858

      Remove the bolt and separate the No. 1 air cleaner inlet.

  7. REMOVE ECM

    1. A345859

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note:

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. A345860

      Remove the 2 bolts and disengage the guide to remove the ECM.

      Note:

      If the ECM has been struck or dropped, replace it.

  8. REMOVE NO. 1 ECM BRACKET

    A345861
    1. Remove the 2 screws and No. 1 ECM bracket from the ECM.

  9. REMOVE NO. 2 ECM BRACKET

    A345862
    1. Remove the 2 screws and No. 2 ECM bracket from the ECM.