REAR COMBINATION LIGHT ASSEMBLY(except Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE

  1. REMOVE DECK BOARD ASSEMBLY (for Hatchback)

    w/ Deck Board:

    Click hereClick here

  2. REMOVE REAR FLOOR MAT ASSEMBLY (for Hatchback)

  3. REMOVE REAR DECK FLOOR BOX (for Hatchback)

    w/ Deck Floor Box:

    Click hereClick here

  4. REMOVE DECK FLOOR BOX LH (for Hatchback)

    w/ Deck Floor Box:

    Click hereClick here

  5. REMOVE DECK FLOOR BOX RH (for Hatchback)

    for RH Side with Deck Floor Box:

    Click hereClick here

  6. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY (for Hatchback)

    w/ Package Tray Trim:

    Click hereClick here

  7. REMOVE REAR DECK TRIM COVER (for Hatchback)

  8. REMOVE NO. 2 DECK SIDE TRIM HOOK (for Hatchback)

  9. REMOVE LOWER DECK TRIM SIDE BOARD (for Hatchback)

    w/ Deck Board:

    Click hereClick here

  10. REMOVE DECK BOARD SUB-ASSEMBLY (for Wagon)

    w/ Deck Board:

    Click hereClick here

  11. REMOVE DECK BOARD ASSEMBLY (for Wagon)

    w/ Deck Board:

    Click hereClick here

  12. REMOVE FRONT DECK FLOOR BOX (for Wagon)

    w/ Deck Board:

    Click hereClick here

  13. REMOVE REAR FLOOR MAT ASSEMBLY (for Wagon)

  14. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (for Wagon)

    for LH Side with Deck Board:

    Click hereClick here

  15. REMOVE DECK FLOOR BOX LH (for Wagon)

    for LH Side without Woofer:

    Click hereClick here

  16. REMOVE NO. 2 DECK BOARD SUB-ASSEMBLY (for Wagon)

    for RH Side with Deck Board:

    Click hereClick here

  17. REMOVE DECK FLOOR BOX RH (for Wagon)

    for RH Side:

    Click hereClick here

  18. REMOVE TONNEAU COVER ASSEMBLY (for Wagon)

  19. REMOVE ROOM PARTITION NET ASSEMBLY (for Wagon)

    w/ Partition Net:

    Click hereClick here

  20. REMOVE REAR DECK TRIM COVER (for Wagon)

  21. REMOVE NO. 2 DECK SIDE TRIM HOOK (for Wagon)

  22. REMOVE RECLINING REMOTE CONTROL BEZEL (for Wagon)

  23. SEPARATE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    1. B330896C01

      *a

      Protective Tape

      for Clip Type:

      1. Using a clip remover, disengage the clip and guide to remove the deck trim service hole cover.

        Tip:

        Tape the clip remover tip before use.

    2. for Hook Type:

      1. B330897

        Remove the bolt.

      2. Disengage the guide to remove the luggage hold belt striker assembly.

    3. for Hatchback:

      1. E393057

        Disengage the 2 claws, 3 clips and 2 guides.

    4. for Wagon:

      1. E402767

        Remove the bolt.

      2. Disengage the 6 claws and 3 clips.

    5. Disconnect each connector to separate the deck trim side panel assembly LH.

  24. SEPARATE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Tip:

    Use the same procedure as for the LH side.

  25. REMOVE REAR COMBINATION LIGHT ASSEMBLY

    1. E393060

      Disconnect the connector.

    2. E322602C01

      *a

      Pin

      *b

      Guide

      Remove the 2 screws.

    3. Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the pin and 3 guides and separate the rear combination light assembly.

      Note:

      To prevent the rear combination light assembly from falling when disengaging the pin and guides, make sure to hold the rear combination light assembly.

    4. E393061

      Disengage the grommet to remove the rear combination light assembly.