FUEL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL FUEL PIPE PLUG SUB-ASSEMBLY

    1. Install a new O-ring, new No. 1 fuel injector back-up ring, new No. 2 fuel injector back-up ring and new No. 3 fuel injector back-up ring to the fuel pipe plug sub-assembly as shown in the illustration.

      A381153C02

      *1

      Fuel Pipe Plug Sub-assembly

      *2

      No. 1 Fuel Injector Back-up Ring

      *3

      No. 2 Fuel Injector Back-up Ring

      *4

      No. 3 Fuel Injector Back-up Ring

      *5

      O-ring

      -

      -

      *a

      Opening

      *b

      Overlapped

      *c

      Stretched

      *d

      Correct

      *e

      Incorrect

      -

      -

      Note:
      • Check that there is no foreign matter or damage on the O-ring groove of the fuel pipe plug sub-assembly.

      • Check that the No. 1 fuel injector back-up ring and No. 3 fuel injector back-up ring are installed in the correct orientation.

      • Make sure that the No. 1 fuel injector back-up ring, No. 2 fuel injector back-up ring, No. 3 fuel injector back-up ring and O-ring are installed in the correct order.

      • Check that the opening of the No. 1 fuel injector back-up ring is not overlapped or stretched as shown in the illustration.

      • After installing the O-ring, check that it is not contaminated with foreign matter and is not damaged.

    2. Install the dust cap sub-assembly to the fuel pipe plug sub-assembly.

    3. A381154

      Install a new gasket to the fuel pipe plug sub-assembly as shown in the illustration.

    4. Secure the fuel delivery pipe in a vise between aluminum plates.

      Note:

      Do not overtighten the vise.

    5. Using a 5 mm hexagon socket wrench, install the fuel pipe plug sub-assembly to the fuel delivery pipe with the 2 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

    6. Remove the fuel delivery pipe from the vise.

  2. INSTALL FUEL DELIVERY PIPE (FUEL PRESSURE SENSOR)

    Tip:

    Perform "Inspection After Repair" after replacing the fuel delivery pipe (fuel pressure sensor).

    Click hereClick here

    Click hereClick here

    Note:
    • Do not remove the fuel pressure sensor from the fuel delivery pipe.

    • If the fuel pressure sensor is removed, replace the fuel delivery pipe (fuel pressure sensor) with a new one.

  3. PERFORM INITIALIZATION

    1. Perform "Inspection After Repair" after replacing the fuel delivery pipe (fuel pressure sensor).

      Click hereClick here