CAN COMMUNICATION SYSTEM(w/ Central Gateway ECU) Brake Actuator (Skid Control ECU) Communication Stop Mode
| DTC Code | DTC Name |
|---|---|
| Brake Actuator (Skid Control ECU) Communication Stop Mode |
DESCRIPTION
Detection Item |
Symptom |
Trouble Area |
|---|---|---|
Brake Actuator (Skid Control ECU) Communication Stop Mode |
Either condition is met:
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Because the order of diagnosis is important to allow correct diagnosis, make sure to begin troubleshooting using How to Proceed with Troubleshooting when CAN communication system related DTCs are output.
Before measuring the resistance of the CAN bus, turn the ignition switch off and leave the vehicle for 1 minute or more without operating the key or any switches, or opening or closing the doors. After that, disconnect the cable from the negative (-) battery terminal and leave the vehicle for 1 minute or more before measuring the resistance.
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
After performing repairs, perform the DTC check procedure and confirm that the DTCs are not output again.
DTC check procedure: Turn the ignition switch to ON and wait at least 12.34 seconds, and then drive the vehicle at a speed of 6 km/h (4 mph) or more for 6 seconds or more.
After the repair, perform the CAN bus check and check that all the ECUs and sensors connected to the CAN communication system are displayed.
Inspect the fuses for circuits related to this system before performing the following procedure.
Before disconnecting related connectors for inspection, push in on each connector body to check that the connector is not loose or disconnected.
When a connector is disconnected, check that the terminals and connector body are not cracked, deformed or corroded.
PROCEDURE
CHECK DTC (BRAKE CONTROL SYSTEM)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Chassis / ABS/VSC/TRC / Trouble Codes.
Chassis > ABS/VSC/TRC > Trouble Codes
Check that DTC C1241 which indicates a malfunction in the power source circuit of the brake control system is not stored by the brake control system.
Result
Result
Proceed to
DTC C1241 is not output
A
DTC C1241 is output
B
CHECK FOR OPEN IN CAN BUS LINES (BRAKE ACTUATOR ASSEMBLY BRANCH LINE)
Disconnect the cable from the negative (-) battery terminal.
Disconnect the A97 brake actuator assembly connector.
-
*a
Front view of wire harness connector
(to Brake Actuator Assembly)
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
A97-26 (CANH) - A97-14 (CANL)
Cable disconnected from negative (-) battery terminal
54 to 69 Ω
Result
Result
OK
NG
NG REPAIR OR REPLACE CAN BRANCH LINES OR CONNECTOR (BRAKE ACTUATOR ASSEMBLY)