MANUAL TRANSAXLE SYSTEM FREEZE FRAME DATA

  1. DESCRIPTION

    A103809E88

    The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

    Tip:

    If it is impossible to replicate the problem even though a DTC is detected, confirm the freeze frame data.

    The ECM records engine conditions in the form of freeze frame data every 0.5 seconds. Using the GTS, 5 separate sets of freeze frame data can be checked.

    • 3 data sets before the DTC was stored.

    • 1 data set when the DTC was stored.

    • 1 data set after the DTC was stored.

    These data sets can be used to simulate the condition of the vehicle around the time of the occurrence the malfunction. The data may assist in identifying the cause of the malfunction, and judging whether it was temporary or not.

  2. LIST OF FREEZE FRAME DATA

    Powertrain > Transmission

    Tester Display

    Vehicle Speed

    Engine Speed

    Calculate Load

    Coolant Temperature

    Intake Air Temperature

    Engine Run Time

    Battery Voltage

    BATT Voltage

    Throttle Position Sensor No.1 Voltage %

    Starter SW

    Neutral Position SW

    Clutch SW

    Stop Light SW

    Cruise Main SW

    TC Terminal

    Running Time from MIL ON

    Time after DTC Cleared

    Distance from DTC Cleared

    Warmup Cycle Cleared DTC

    Total Distance Traveled

    Total Distance Traveled

    Accel Position from EFI

    Shift SW Status (R Range)