REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

  1. INSTALL REAR CRANKSHAFT OIL SEAL

    1. Apply MP grease to the lip of a new rear crankshaft oil seal.

    2. A202329N01

      Using SST and a hammer, tap in the rear crankshaft oil seal as shown in the illustration.

      09223-56010

      Standard Depth

      0 to 0.9 mm (0 to 0.0354 in.)

      Note:
      • Keep the lip free from foreign matter.

      • Do not tap in the rear crankshaft oil seal at an angle.

      • Make sure that the rear crankshaft oil seal is properly installed.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY

  3. INSTALL CLUTCH DISC ASSEMBLY

  4. INSTALL CLUTCH COVER ASSEMBLY

  5. INSPECT AND ADJUST CLUTCH COVER ASSEMBLY

  6. INSTALL MANUAL TRANSAXLE ASSEMBLY