EGR VALVE INSTALLATION

PROCEDURE

  1. INSTALL EGR VALVE (ELECTRIC EGR CONTROL VALVE ASSEMBLY)

    1. A293446C01

      *a

      Protrusion

      Install a new gasket.

      Note:

      Make sure the protrusion of the gasket is facing upward as shown in the illustration.

    2. Install the EGR valve (electric EGR control valve assembly).

  2. INSTALL NO. 2 EGR PIPE SUB-ASSEMBLY

    1. Install a new gasket to the EGR valve (electric EGR control valve assembly).

    2. A293445C02

      *a

      Bolt A

      *b

      Bolt B

      V100135

      Bolt

      V100136

      Nut

      Temporarily install the No. 2 EGR pipe sub-assembly with the 3 bolts and 2 nuts.

      Bolt Length

      Item

      Specified Condition

      Bolt A

      25 mm (0.984 in.)

      Bolt B

      70 mm (2.76 in.)

    3. Tighten the 2 bolts (A) shown in the illustration.

      24 N*m

      245 kgf*cm

      18 ft.*lbf

    4. Tighten the bolt (B) and 2 nuts shown in the illustration.

      24 N*m

      245 kgf*cm

      18 ft.*lbf

    5. Connect the electric EGR control valve connector to the EGR valve (electric EGR control valve assembly).

  3. CONNECT NO. 8 WATER BY-PASS HOSE

    1. Connect the No. 8 water by-pass hose to the EGR valve (electric EGR control valve assembly) and slide the clip to secure it.

  4. CONNECT NO. 7 WATER BY-PASS HOSE

    1. Connect the No. 7 water by-pass hose to the EGR valve (electric EGR control valve assembly) and slide the clip to secure it.

  5. INSTALL EGR VALVE BRACKET

    1. Install the 2 EGR valve brackets with the 3 bolts.

      24 N*m

      245 kgf*cm

      18 ft.*lbf

    2. Connect the 2 connectors and the 2 wire harness clamps.

  6. ADD ENGINE COOLANT

  7. INSPECT FOR COOLANT LEAK

  8. INSTALL NO. 1 ENGINE COVER

  9. PERFORM INITIALIZATION

    1. When replacing the EGR valve (electric EGR control valve assembly), perform initialization.

      Click here