REAR CENTER SEAT OUTER BELT ASSEMBLY(for Sedan) INSPECTION

PROCEDURE

  1. INSPECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY RH

    1. B345528C01

      *a

      Retractor

      *b

      Unlocked

      *c

      Locked

      *d

      45°

      Before installing the rear seat inner with center belt assembly RH, check the ELR function.

      Note:

      Do not disassemble the retractor.

      When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.

      If the result is not as specified, replace the rear seat inner with center belt assembly RH.

    2. Check the switch of the rear seat belt warning system. (w/ Rear Seat Belt Warning)

      1. B332791C02

        *a

        Component without harness connected

        (Rear Seat Inner with Center Belt Assembly RH)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        1 - 2

        Rear seat belt RH unfastened

        Below 1 Ω

        1 - 2

        Rear seat belt RH fastened

        10 kΩ or higher

        If the result is not as specified, replace the rear seat inner with center belt assembly RH.