CAMSHAFT INSTALLATION

CAUTION / NOTICE / HINT

Note:
  • When replacing the injector assemblies (including exchanging the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head, it is necessary to replace the injection pipe sub-assemblies with new ones.

  • When replacing the supply pump assembly, common rail assembly, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.

PROCEDURE

  1. INSPECT VALVE LASH ADJUSTER ASSEMBLY

  2. INSTALL VALVE LASH ADJUSTER ASSEMBLY

    1. Install the 16 valve lash adjuster assemblies to the cylinder head sub-assembly.

      Note:

      Install the valve lash adjuster assemblies to their original positions.

  3. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

    1. Install the 16 No. 1 valve rocker arm sub-assemblies to the valve lash adjuster assemblies.

  4. INSTALL CAMSHAFT

    1. Install the No. 2 camshaft bearing cap.

    2. A294393C01

      *a

      Apply Engine Oil

      Apply clean engine oil to the cam lobes of each camshaft, journals of the cylinder head sub-assembly and No. 1 valve rocker arm sub-assemblies.

    3. A294394C02

      *a

      No. 3 Cylinder Cam Lobe

      *b

      No. 1 Cylinder Cam Lobe

      Place the No. 2 camshaft on the cylinder head sub-assembly as shown in the illustration so that the No. 1 and No. 3 cylinder cam lobes face upward.

      A111377C04

      *1

      No. 1 Valve Rocker Arm Sub-Assembly

      *2

      Valve Lash Adjuster Assembly

      *a

      Correct

      *b

      Incorrect

      *c

      Valve Stem

      Note:

      Before and after setting the camshaft and No. 2 camshaft on the cylinder head sub-assembly, check that each No. 1 valve rocker arm sub-assembly is securely installed to the valve lash adjuster assembly.

    4. A111212C04

      *a

      Dot Mark

      Align the camshaft and No. 2 camshaft timing mark (1 dot mark each).

    5. Place the camshaft on the cylinder head sub-assembly.

    6. A266899

      Set the 8 No. 3 camshaft bearing caps and No. 1 camshaft bearing cap on the camshafts as shown in the illustration.

      Tip:

      Check the marks and numbers on the camshaft bearing caps and place them in the proper position and direction.

    7. Temporarily tighten the 20 bolts.

    8. A294404C04

      *a

      Oil Pipe Seat

      Uniformly tighten the bolts in several steps, in the order shown in the illustration.

      for 1 to 16

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      for 17 to 20

      21 N*m

      214 kgf*cm

      15 ft.*lbf

    9. Install the 2 oil pipe seats.

      17 N*m

      173 kgf*cm

      13 ft.*lbf

  5. INSTALL CAMSHAFT TIMING SPROCKET

  6. INSTALL OIL PUMP DRIVE GEAR

  7. INSTALL NO. 1 CHAIN VIBRATION DAMPER

  8. INSTALL CHAIN TENSIONER SLIPPER

  9. INSTALL NO. 1 CHAIN TENSIONER ASSEMBLY

  10. INSTALL SUPPLY PUMP ASSEMBLY

  11. INSTALL TIMING CHAIN COVER SUB-ASSEMBLY