DRIVE BELT INSTALLATION
PROCEDURE
INSTALL V-RIBBED BELT
Using SST and a 22 mm wrench, rotate the V-ribbed belt tensioner assembly counterclockwise, and then install the V-ribbed belt.
09216-42010
CAUTION:Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.
Be careful that your hands do not become jammed between parts such as the V-ribbed belt, pulleys, etc.
Note:Make sure that the V-ribbed belt is set properly on each pulley.
Make sure SST is installed as shown in the illustration. If not, SST and/or the V-ribbed belt may not be able to be removed.
INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH
-
Install the front suspension member reinforcement RH with the 4 bolts.
99 N*m
1010 kgf*cm
73 ft.*lbf
Note:Temporarily tighten bolts A and B, and then fully tighten the 4 bolts in the order of C, B, D and A.
-
INSTALL REAR ENGINE UNDER COVER RH
INSTALL NO. 1 ENGINE UNDER COVER
INSTALL FRONT WHEEL RH
103 N*m
1050 kgf*cm
76 ft.*lbf