AUDIO AND VISUAL SYSTEM(except Sedan Radio and Display Type) AVC-LAN Circuit

DTC Code DTC Name
AVC-LAN Circuit

DESCRIPTION

Each unit of the audio and visual system connected to the AVC-LAN (communication bus) transfers switch signals using the AVC-LAN.

If a short to +B or short to ground occurs in the AVC-LAN, the audio and visual system will not function normally because communication is not possible.

WIRING DIAGRAM

E226159E30

CAUTION / NOTICE / HINT

Tip:

The radio and display receiver assembly is the master unit.

PROCEDURE

  1. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

    1. Remove the radio and display receiver assembly.

    2. E221758C04

      *a

      Component without harness connected

      (Radio and Display Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      7 (TX1+) - 8 (TX1-)

      Always

      60 to 80 Ω

    Result

    Proceed to

    OK

    NG

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

    OK
  2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)

    1. Disconnect the E60 radio and display receiver assembly connector.

    2. Disconnect the E92 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E92-8 (TX+) - E60-7 (TX1+)

      Always

      Below 1 Ω

      E92-7 (TX-) - E60-8 (TX1-)

      Always

      Below 1 Ω

      E92-8 (TX+) - Body ground

      Always

      10 kΩ or higher

      E92-7 (TX-) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK
  3. INSPECT MALFUNCTIONING PARTS

    1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

      Tip:
      • Check all slave units.

      • If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

      OK

      Master unit returns to normal operation.

    Result

    Proceed to

    OK

    NG

    OK

    REPLACE MALFUNCTIONING PARTS

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY