PATTERN SELECT SWITCH INSPECTION

PROCEDURE

  1. INSPECT Es MODE SWITCH (COMBINATION SWITCH ASSEMBLY)

    1. Make sure that there is no looseness in the locking part and the connecting part of the connector.

    2. Disconnect the Es mode switch (combination switch assembly) connector.

    3. Check both the connector case and the terminal for deformation and corrosion.

      OK

      No deformation or corrosion.

    4. A351128C20

      *a

      Component without harness connected

      (Es mode Switch (Combination Switch Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      3 (E) - 8 (MSW1)

      Switch pushed in

      Below 50 Ω

      Switch not pushed in

      10 kΩ or higher

      If the result is not as specified, replace the Es mode switch (combination switch assembly).

    5. A351128C21

      *a

      Component without harness connected

      (Es mode Switch (Combination Switch Assembly))

      Apply battery voltage between the terminals of the switch and check the illumination condition of the Es mode switch (combination switch assembly).

      Standard

      Measurement Condition

      Specified Condition

      Battery positive (+) → 6 (ILL+)

      Battery negative (-) → 5 (ILL-)

      Illuminates

      If the result is not as specified, replace the Es mode switch (combination switch assembly).