REAR STABILIZER BAR INSTALLATION

PROCEDURE

  1. INSTALL REAR STABILIZER BUSHING

    1. C272893C02

      *a

      Stopper

      Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

  2. INSTALL REAR NO. 1 STABILIZER BAR BRACKET

    1. C272892C01

      *a

      Identification Mark

      V100135

      Front of the Vehicle

      Install the rear No. 1 stabilizer bar bracket to the 2 rear stabilizer bushings.

      Note:

      Ensure that the identification mark is on the right side of the vehicle.

  3. INSTALL REAR STABILIZER BAR

    1. C273341C01

      *a

      Identification Mark

      V100136

      Front of the Vehicle

      Temporarily install the rear stabilizer bar, 2 rear stabilizer bushings and rear No. 1 stabilizer bar bracket to the rear suspension member sub-assembly with the 4 bolts.

      Note:

      Ensure that the identification mark is on the right side of the vehicle.

    2. Fully tighten the 4 bolts.

      78 N*m

      795 kgf*cm

      58 ft.*lbf

  4. INSTALL REAR STABILIZER LINK ASSEMBLY LH

    Note:

    Since the rear stabilizer link assembly LH, rear stabilizer cushions and nut (B) are not reusable, new parts must be installed.

    1. C211882C02
      V100135

      Nut (A)

      V100136

      Nut (B)

      Install a new rear stabilizer link assembly LH and 2 new rear stabilizer cushions to the rear No. 2 suspension arm assembly with a new nut (B) as shown in the illustration.

      30 N*m

      306 kgf*cm

      22 ft.*lbf

      Note:

      Be sure to install the rear stabilizer cushions in the correct direction as shown in the illustration.

    2. Install the rear stabilizer link assembly LH to the rear stabilizer bar with the nut (A).

      95 N*m

      969 kgf*cm

      70 ft.*lbf

      Tip:

      If the ball joint turns together with the nut, use a 6 mm hexagon socket wrench to hold the stud bolt.

    3. C211884N03

      Adjust the rear stabilizer link assembly LH so that A and B are parallel as shown in the illustration.

  5. INSTALL REAR STABILIZER LINK ASSEMBLY RH

    Tip:

    Perform the same procedure as the LH side.

  6. INSTALL REAR SUSPENSION MEMBER BRACE LH

    1. Install the rear suspension member brace LH to the rear suspension member sub-assembly with the 3 bolts.

      35 N*m

      357 kgf*cm

      26 ft.*lbf

  7. INSTALL REAR SUSPENSION MEMBER BRACE RH

    Tip:

    Perform the same procedure as the LH side.