INTEGRATION RELAY REMOVAL
PROCEDURE
REMOVE ECM
REMOVE FRONT FENDER LINER LH
REMOVE NO. 1 RELAY BLOCK COVER
SEPARATE WIRE HARNESS
-
Remove the 2 nuts.
Disconnect the 2 connectors and disengage the 2 clamps to separate the wire harness.
-
SEPARATE ENGINE ROOM RELAY BLOCK AND LOWER RELAY BLOCK COVER
for LHD:
-
Disconnect the wireless door lock buzzer connector.
-
-
Disconnect the front speed sensor connector.
-
Disengage the 2 wire harness clamps to separate the wire harness.
-
*a
Guide
*b
Clamp
Disengage the 2 wire harness clamps.
Remove the 3 bolts.
Disengage the claw and guide, and push the engine room relay block and lower relay block cover toward the inside of the engine compartment.
Note:Do not forcibly push the engine room relay block and lower relay block cover as a wire harness is still connected.
-
Disengage the 10 claws and separate the engine room relay block from the lower relay block cover.
-
Disengage the 4 claws and remove the wire harness cover.
REMOVE NO. 1 INTEGRATION RELAY
-
Disengage the 2 claws and pull the No. 1 integration relay out from the engine room relay block.
Tip:By spreading the wire harness indicated by the circle in the illustration, the No. 1 integration relay is easier to pull out.
Disconnect the 3 No. 1 integration relay connectors to remove the No. 1 integration relay.
-