REAR AXLE HUB(for Double Wishbone Type Suspension) INSTALLATION

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH side and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE

  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

    1. Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the new 4 bolts.

      90 N*m

      918 kgf*cm

      66 ft.*lbf

  2. CONNECT SKID CONTROL SENSOR WIRE

  3. INSPECT REAR AXLE HUB BEARING LOOSENESS

  4. INSPECT REAR AXLE HUB RUNOUT

  5. INSTALL REAR DISC

  6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

  7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

  8. INSTALL PARKING BRAKE LEVER PROTECTOR

  9. ADJUST PARKING BRAKE

  10. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

  11. INSTALL REAR WHEEL

    103 N*m

    1050 kgf*cm

    76 ft.*lbf

  12. CHECK FOR SPEED SENSOR SIGNAL