POWER WINDOW REGULATOR MOTOR(for Hatchback Rear Side, Wagon Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick hereClick here

  3. REMOVE REAR ARMREST ASSEMBLY

  4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  6. REMOVE REAR DOOR SERVICE HOLE COVER

    1. B334204

      Disconnect the connector.

    2. Remove the rear door service hole cover.

      Click hereClick here

  7. DISCONNECT REAR DOOR WEATHERSTRIP

  8. DISCONNECT REAR DOOR GLASS RUN

  9. REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

  10. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  11. REMOVE REAR DOOR GLASS RUN

  12. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY