SHIFT PADDLE SWITCH INSPECTION
PROCEDURE
INSPECT SHIFT PADDLE SWITCH
-
*a
Component without harness connected
(Shift Paddle Switch LH)
*b
Component without harness connected
(Shift Paddle Switch RH)
Measure the resistance according to the values in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
3 (SFTU) - 2 (ECC1)
"+" continuously pulled
Below 2.5 Ω
Released
1 MΩ or higher
2 (SFTD) - 3 (ECC)
"-" continuously pulled
Below 2.5 Ω
Released
1 MΩ or higher
2 (SFTD) - 4 (ECC1)
"-" continuously pulled
Below 2.5 Ω
Released
1 MΩ or higher
If the resistance is not as specified, replace the shift paddle switch.
-