CRUISE CONTROL SYSTEM(for 1ND-TV with Driving support ECU)

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:
  • Use the following procedure to troubleshoot the cruise control system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT

    NEXT
  2. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage with the ignition switch off.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT

    NEXT
  3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

    1. Use the GTS to check if the CAN communication system is functioning normally.

    Result

    Result

    Proceed to

    CAN DTCs are not output

    A

    CAN DTCs are output

    B

    B

    GO TO CAN COMMUNICATION SYSTEM

    A
  4. CHECK FOR DTC*

    Refer to DTC Check / Clear.

    Click here

    1. Check for DTCs and note any codes that are output.

      Click here

    2. Clear the DTCs.

      Click here

    3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

    Result

    Result

    Proceed to

    DTC does not reoccur

    A

    DTC reoccurs

    B

    B

    GO TO DTC CHART

    A
  5. PROBLEM SYMPTOMS TABLE

    Refer to Problem Symptoms Table.

    Click here

    Result

    Result

    Proceed to

    Fault is not listed in Problem Symptoms Table

    A

    Fault is listed in Problem Symptoms Table

    B

    B

    ADJUST, REPAIR OR REPLACEClick here

    A
  6. OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Terminals of ECU

      Click hereClick here

    2. Data List / Active Test

      Click hereClick here

    Result

    Proceed to

    NEXT

    NEXT
  7. ADJUST, REPAIR OR REPLACE

    Result

    Proceed to

    NEXT

    NEXT
  8. CONFIRMATION TEST

    Result

    Proceed to

    NEXT

    NEXT

    END