STARTER(w/ Stop And Start System) REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:
    • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

      Click hereClick here

    • When the starter assembly is replaced, "starter relay assembly" must be also replaced.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  5. REMOVE FLYWHEEL HOUSING SIDE COVER

    1. A288535

      Disengage the claw by pulling the flywheel housing side cover outward and remove the flywheel housing side cover.

  6. REMOVE STARTER ASSEMBLY

    1. A249485

      Disengage the 2 clamps.

    2. A259059

      Open the terminal cap.

    3. Remove the nut and disconnect terminal 30.

    4. Disconnect the connector.

    5. A262314

      Remove the 2 bolts and starter assembly.