FRONT DRIVE SHAFT ASSEMBLY(for 1NR-FE) REMOVAL
CAUTION / NOTICE / HINT
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
REMOVE FRONT WHEELS
REMOVE REAR ENGINE UNDER COVER LH
REMOVE REAR ENGINE UNDER COVER RH
DRAIN MANUAL TRANSAXLE OIL
REMOVE FRONT AXLE SHAFT NUT
-
Using SST and a hammer, release the staked part of the front axle shaft nut.
09930-00010
Note:Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.
While applying the brakes, remove the front axle shaft nut.
-
SEPARATE FRONT SPEED SENSOR
SEPARATE FRONT FLEXIBLE HOSE
SEPARATE TIE ROD END SUB-ASSEMBLY
SEPARATE FRONT STABILIZER LINK ASSEMBLY
SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
SEPARATE FRONT DRIVE SHAFT ASSEMBLY
REMOVE FRONT DRIVE SHAFT ASSEMBLY LH
-
Using SST, remove the front drive shaft assembly LH.
09520-01010
09520-24010
09520-32040
Note:Do not damage the transmission case oil seal.
Do not damage the front axle inboard joint boot.
Do not drop the front drive shaft assembly LH.
-
REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
Tip:Perform the same procedure as for the LH side.
REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH
-
Using a screwdriver, remove the front drive shaft hole snap ring.
-