RELAY ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT GLOW PLUG RELAY ASSEMBLY

    A199031E02
    1. Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        3 - 4

        Battery voltage not applied

        10 kΩ or higher

        Battery voltage applied to terminals 1 and 2

        Below 1 Ω

        If the result is not as specified, replace the glow plug relay assembly.

  2. INSPECT STARTER RELAY ASSEMBLY

    1. E209082

      Check the resistance.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        If the result is not as specified, replace the starter relay assembly.

        If the result is not as specified, replace therelay.

        Tester Connection

        Condition

        Specified Condition

        3 - 5

        Battery voltage not applied

        10 kΩ or higher

        Battery voltage applied to terminals 1 and 2

        Below 1 Ω

        If the result is not as specified, replace the starter relay assembly.