FUEL SUPPLY PUMP REMOVAL

CAUTION / NOTICE / HINT

Note:
  • When replacing the injector assemblies (including exchanging the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head, it is necessary to replace the injection pipes with new ones.

  • When replacing the supply pump assembly, common rail assembly, intake manifold or cylinder head, it is necessary to replace the fuel inlet pipe with a new one.

Tip:

After replacing the supply pump assembly, perform the "SUPPLY PUMP INITIALIZATION PROCEDURE" function using the GTS.

Click here

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE NO. 1 ENGINE COVER

  4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

  6. REMOVE NO. 3 FUEL HOSE

    1. A203046

      Slide the 2 clips and remove the No. 3 fuel hose.

  7. REMOVE NO. 1 FUEL HOSE

    1. A203052

      Slide the 2 clips and remove the No. 1 fuel hose.

  8. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

    Note:

    After removing the fuel inlet pipe sub-assembly, cover the common rail assembly and supply pump assembly to prevent contamination.

    1. A203053

      Remove the nut and injection pipe clamp.

    2. Using a 14 mm union nut wrench, loosen the 2 nuts to remove the fuel inlet pipe sub-assembly.

  9. REMOVE FUEL HOSE PROTECTOR

  10. REMOVE FUEL TUBE SUB-ASSEMBLY

    1. A203047

      Disconnect the exhaust fuel addition injector assembly connector.

    2. A203048

      Turn the retainer as shown in the illustration.

      Note:
      • Check that there are no scratches or foreign matter around the connecting parts of the fuel tube connector and exhaust fuel addition injector assembly before performing this work.

      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the exhaust fuel addition injector assembly.

      • Only disconnect the fuel tube connector by hand.

      • Protect the disconnected part by covering it with a plastic bag after disconnecting the fuel tube connector.

      • If the fuel tube connector and exhaust fuel addition injector assembly are stuck, push and pull to release them.

    3. A203049

      Disconnect the fuel tube sub-assembly from the exhaust fuel addition injector assembly.

    4. A211354C03

      *1

      Check Valve

      *a

      Union Bolt

      Remove the check valve and gasket.

    5. Remove the union bolt and fuel tube sub-assembly with the gasket.

  11. REMOVE SUPPLY PUMP ASSEMBLY

    1. A203054

      Disconnect the fuel temperature sensor connector.

    2. Disconnect the suction control valve assembly connector.

    3. A203055

      Remove the 2 bolts, supply pump assembly and supply pump drive coupling.

    4. Remove the O-ring from the supply pump assembly.