CAMSHAFT POSITION SENSOR INSTALLATION

PROCEDURE

  1. INSTALL CAMSHAFT POSITION SENSOR

    1. A158220

      for Intake Side

      1. Apply a light coat of engine oil to the O-ring.

        Note:

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Apply adhesive to 2 or 3 threads at the end of the bolt.

        Adhesive

        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

        Tip:
        • If the removed bolt did not have adhesive applied to it, make sure to apply adhesive to the threads of the bolt before installing it.

        • If the removed bolt had adhesive applied to it, make sure to clean the bolt and bolt hole and apply adhesive to the threads of the bolt before installing it.

      3. Install the camshaft position sensor onto the cylinder head cover sub-assembly with the bolt.

        10 N*m

        102 kgf*cm

        7 ft.*lbf

        Note:
        • If a component has been dropped or subjected to a strong impact, replace it.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      4. Connect the connector of the camshaft position sensor.

    2. A158220

      for Exhaust Side

      1. Apply a light coat of engine oil to the O-ring.

        Note:

        If reusing the camshaft position sensor, be sure to inspect the O-ring.

      2. Apply adhesive to 2 or 3 threads at the end of the bolt.

        Adhesive

        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

        Tip:
        • If the removed bolt did not have adhesive applied to it, make sure to apply adhesive to the threads of the bolt before installing it.

        • If the removed bolt had adhesive applied to it, make sure to clean the bolt and bolt hole and apply adhesive to the threads of the bolt before installing it.

      3. Install the camshaft position sensor to the cylinder head cover sub-assembly with the bolt.

        10 N*m

        102 kgf*cm

        7 ft.*lbf

        Note:
        • If a component has been dropped or subjected to a strong impact, replace it.

        • Make sure that the O-ring is not damaged or does not jump out of position during installation.

      4. Connect the connector of the camshaft position sensor.

  2. INSPECT FOR ENGINE OIL LEAK

  3. INSTALL NO. 1 ENGINE COVER