FRONT CRANKSHAFT OIL SEAL REMOVAL
PROCEDURE
REMOVE FRONT WHEEL RH
REMOVE REAR ENGINE UNDER COVER RH
REMOVE V-RIBBED BELT
REMOVE CRANKSHAFT PULLEY
-
*a
Hold

Turn
Using SST, remove the crankshaft pulley bolt.
09960-10010
09962-01000
09963-01000
Remove the crankshaft pulley from the crankshaft.
-
REMOVE TIMING CHAIN COVER OIL SEAL
-
*a
Pry
*b
Cut Position
*c
Protective Tape
Using a knife, cut off the timing chain cover oil seal lip.
Using a screwdriver with its tip wrapped with tape, pry out the timing chain cover oil seal.
Note:After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.
-