QUARTER WINDOW GLASS(for Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. REMOVE DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  2. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

  3. REMOVE FRONT DECK FLOOR BOX (w/ Deck Board)

  4. REMOVE REAR FLOOR MAT ASSEMBLY

  5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Deck Board)

  6. REMOVE DECK FLOOR BOX LH (w/o Woofer)

  7. REMOVE TONNEAU COVER ASSEMBLY

  8. REMOVE ROOM PARTITION NET ASSEMBLY (w/ Partition Net)

  9. REMOVE REAR DECK TRIM COVER

  10. REMOVE REAR SEAT CUSHION ASSEMBLY

  11. REMOVE REAR SEAT HEADREST ASSEMBLY

  12. DISCONNECT REAR NO. 1 SEAT LOCK CABLE ASSEMBLY

  13. REMOVE REAR SEATBACK ASSEMBLY LH

  14. REMOVE REAR DOOR SCUFF PLATE LH

  15. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH

  16. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

  17. REMOVE REAR SEAT SIDE GARNISH LH

  18. REMOVE NO. 2 DECK SIDE TRIM HOOK

  19. REMOVE RECLINING REMOTE CONTROL BEZEL LH

  20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

  21. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

  22. REMOVE QUARTER WINDOW ASSEMBLY

    1. B350590C01
      V100155

      Protective Tape

      Apply protective tape to the area around the installation position of the quarter window assembly on the vehicle body to prevent it from being scratched.

    2. B350591C01

      *1

      Clip

      *a

      Piano Wire

      Pass a piano wire between the vehicle body and quarter window assembly from the interior.

      Note:

      Do not pull the piano wire in a vertical direction, but pull it in a horizontal direction.

    3. Tie both wire ends to wooden blocks or similar objects that can serve as handles.

    4. Cut off the adhesive by pulling the piano wire around the quarter window assembly.

      Note:

      When separating the quarter window assembly, be careful not to damage the paint or interior and exterior ornaments.

    5. B350592

      Using suction cups, disengage the 3 clips and remove the quarter window assembly.

      Note:
      • Be careful not to drop the quarter window assembly.

      • Be sure to replace the quarter window assembly with a new one.

  23. CLEAN VEHICLE BODY

    1. B327220C03

      *a

      Vehicle Body

      V100155

      Adhesive

      Clean and shape the contact surfaces of the vehicle body.

      Standard Dimension

      Area

      Dimension

      a

      1.0 mm (0.0394 in.) or more

      1. Using a knife, cut away excess adhesive on the contact surfaces of the vehicle body as shown in the illustration.

        Note:

        Be careful not to damage the vehicle body.

        Tip:

        Leave as much adhesive on the vehicle body as possible.

    2. Clean the contact surfaces of the vehicle body with a piece of cloth saturated with non-residue solvent.

      Tip:

      Even if all the adhesive has been removed, clean the vehicle body.