FUEL TEMPERATURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL FUEL TEMPERATURE SENSOR

    Note:

    If the fuel temperature sensor is dropped, replace it with a new one.

    1. Apply a light coat of engine oil to a new O-ring.

    2. Install the O-ring to the fuel temperature sensor.

    3. Temporarily install the fuel temperature sensor to the supply pump assembly.

    4. A321928C01

      *a

      Length of SST 135 mm (5.31 in.)

      *b

      Length of Torque Wrench 180 mm (7.09 in.)

      Using SST, tighten the fuel temperature sensor.

      09922-10010

      without SST [Torque (N*m (kgf*cm, ft.*lbf))]

      22 N*m

      224 kgf*cm

      16 ft.*lbf

      with SST [Reading of Torque wrench (N*m (kgf*cm, ft.*lbf))]

      12.5 N*m

      127 kgf*cm

      9 ft.*lbf

      Tip:
      • This torque value is effective when SST is parallel to the torque wrench.

      • The "with SST" torque value is effective when using SST with a fulcrum length of 135 mm (5.31 in.).

      • The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

      • If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

        Click hereClick here

  2. INSTALL SUPPLY PUMP ASSEMBLY

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  4. PERFORM INITIALIZATION

  5. BLEED AIR FROM FUEL SYSTEM

  6. INSPECT FOR FUEL LEAK