GLOW PLUG CONTROLLER REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick here

  3. REMOVE FRONT WHEEL LH

  4. DISCONNECT FRONT FENDER LINER LH

    1. A354429C01

      *a

      90°

      Using a screwdriver, turn the pin 90 degrees clockwise to remove the pin hold clip.

    2. A354430

      Remove the 2 screws.

    3. A354431

      Remove the 2 clips and disconnect the front fender liner LH.

  5. REMOVE GLOW PLUG CONTROLLER

    1. A354433

      Disconnect the 4 glow plug controller connectors.

    2. A354434

      Remove the 2 bolts and glow plug controller together with the No. 1 glow plug controller bracket from the vehicle body.

  6. REMOVE NO. 1 GLOW PLUG CONTROLLER BRACKET

    1. A354435

      Remove the 2 screws and No. 1 glow plug controller bracket from the glow plug controller.