REAR SPEED SENSOR REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

  • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR WHEEL

  4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

  5. LOOSEN NO. 2 WIRE ADJUSTING NUT

  6. REMOVE PARKING BRAKE LEVER PROTECTOR (for Double Wishbone Type Suspension)

  7. SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

    for Torsion Beam Type Suspension:Click here

    for Double Wishbone Type Suspension:Click here

  8. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

    for Torsion Beam Type Suspension:Click here

    for Double Wishbone Type Suspension:Click here

  9. REMOVE REAR DISC

  10. DISCONNECT SKID CONTROL SENSOR WIRE (for Torsion Beam Type Suspension)

    1. C150171

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note:

      Be careful not to damage the rear speed sensor.

  11. DISCONNECT SKID CONTROL SENSOR WIRE (for Double Wishbone Type Suspension)

    1. C162227

      Using a screwdriver, disconnect the connector from the rear speed sensor.

      Note:

      Be careful not to damage the rear speed sensor.

  12. REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

    1. Remove the rear axle hub and bearing assembly.

      for Torsion Beam Type Suspension:Click here

      for Double Wishbone Type Suspension:Click here

      Tip:
      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.