BACK DOOR OUTSIDE GARNISH(for Hatchback) INSTALLATION
PROCEDURE
INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from the back door outside garnish protector.
Tip:After removing the release paper, keep the exposed adhesive free from foreign matter.
Type A:
Install 3 new back door outside garnish protectors.
*a
Line
-
-
Tip:Stick the 3 back door outside garnish protectors on the lines marked on the back door outside garnish sub-assembly.
Type B:
Install a new back door outside garnish protector.
*a
Line
-
-
Tip:Stick the back door outside garnish protector on the lines marked on the back door outside garnish sub-assembly.
INSTALL NO. 2 BACK DOOR OUTSIDE GARNISH PROTECTOR
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from the No. 2 back door outside garnish protector.
Tip:After removing the release paper, keep the exposed adhesive free from foreign matter.
Install 2 new No. 2 back door outside garnish protectors.
*a
Line
-
-
Tip:Stick the 2 No. 2 back door outside garnish protectors on the line marked on the back door outside garnish sub-assembly.
INSTALL NO. 1 BACK DOOR OUTSIDE GARNISH PROTECTOR
Wipe off any tape adhesive residue with cleaner.
Remove the release paper from the No. 1 back door outside garnish protector.
Tip:After removing the release paper, keep the exposed adhesive free from foreign matter.
Install 2 new No. 1 back door outside garnish protectors.
*a
Line
-
-
Tip:Stick the 2 No. 1 back door outside garnish protectors on the line marked on the back door outside garnish sub-assembly.
INSTALL NO. 1 BACK DOOR EMBLEM
INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY
Install new 8 clips to the back door outside garnish sub-assembly.
-
*1
Back Window Lower Moulding
*a
String
*b
Masking Tape
Pass a string behind the back window lower moulding and tape both ends with masking tape as shown in the illustration.
Engage the 8 clips to install the back door outside garnish sub-assembly.
Tip:Make sure not to dislodge the string under the back window lower moulding.
Apply soapy water to the back window lower moulding.
-
*1
Back Window Lower Moulding
*2
Back Door Outside Garnish Sub-assembly
*a
String
Pull out the string slowly, starting from one end and working to the other end, as shown in the illustration.
Note:Make sure not to damage the back window lower moulding.
Check that the back window lower moulding is not caught behind the back door outside garnish sub-assembly.
Install the 2 bolts.
INSTALL BACK DOOR OPENER SWITCH ASSEMBLY
INSTALL REAR LIGHT ASSEMBLY LH
INSTALL REAR LIGHT ASSEMBLY RH
Tip:Use the same procedure as for the LH side.