AIR FUEL RATIO SENSOR(w/ Glow Plug Controller) REMOVAL

PROCEDURE

  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

  2. REMOVE WATER GUARD PLATE LH

  3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

  4. REMOVE OUTER COWL TOP PANEL

  5. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

  6. REMOVE NO. 1 WIRE HARNESS HEAT INSULATOR

    1. A345867

      Unfasten the 2 buttons.

    2. A345868C01

      *a

      Air Fuel Ratio Sensor Connector

      *b

      Exhaust Gas Temperature Sensor Connector

      Disconnect the 2 air fuel ratio sensor connectors.

    3. Disconnect the exhaust gas temperature sensor connector.

    4. Disengage the clamp.

    5. A345869C01

      *a

      Air Fuel Ratio Sensor Connector

      *b

      Exhaust Gas Temperature Sensor Connector

      Disengage the 2 air fuel ratio sensor connectors from the wire harness clamp bracket.

    6. Disengage the exhaust gas temperature sensor connector from the wire harness clamp bracket.

    7. A354244

      Remove the No. 1 wire harness heat insulator from the wire harness clamp bracket.

  7. REMOVE WIRE HARNESS CLAMP BRACKET

    1. A354245

      Disengage the wire harness clamp.

    2. A354246

      Remove the 2 bolts and wire harness clamp bracket from the No. 2 engine cover bracket.

  8. REMOVE NO. 2 ENGINE COVER BRACKET

    1. A354247

      Remove the 2 nuts and No. 2 engine cover bracket.

  9. REMOVE AIR FUEL RATIO SENSOR (for Sensor 1)

    1. A354248N01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold.

      09224-00011

      Note:

      If the air fuel ratio sensor has been struck or dropped, replace it.

  10. REMOVE AIR FUEL RATIO SENSOR (for Sensor 2)

    1. A354250

      Disengage the 3 wire harness clamps.

    2. A354251N01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold.

      09224-00011

      Note:

      If the air fuel ratio sensor has been struck or dropped, replace it.