CURTAIN SHIELD AIRBAG ASSEMBLY REMOVAL
CAUTION / NOTICE / HINT
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
PROCEDURE
PRECAUTION
Note:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
REMOVE ROOF HEADLINING ASSEMBLY
REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY
CAUTION:When storing the curtain shield airbag assembly, keep the airbag deployment side facing upward.
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
CAUTION:Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
-
*1
Airbag Connector
*2
Airbag Connector Lock
*a
Protective Tape
Using a screwdriver with its tip wrapped with protective tape, release the airbag connector lock and disconnect the airbag connector.
Note:When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Using a clip remover, remove the 6 pins.
Using 2 screwdrivers, disengage the 2 claws and remove each clip from the body panel as shown in the illustration.
*1
Pin
*2
Claw
While holding the curtain shield airbag assembly, remove the 2 bolts and disengage the 4 clips.
Note:When removing the curtain shield airbag assembly, have assistants hold it to prevent it from bending.
Disengage the 2 hooks to remove the curtain shield airbag assembly.
Remove the 2 spacers from the curtain shield airbag assembly.