CAMSHAFT(w/o Glow Plug Controller) REMOVAL

PROCEDURE

  1. INSTALL ENGINE STAND

  2. REMOVE ENGINE COVER BRACKET (w/ No. 1 Engine Cover)

  3. REMOVE GENERATOR ASSEMBLY

  4. REMOVE GENERATOR BRACKET

  5. REMOVE EGR WITH COOLER PIPE ASSEMBLY

  6. REMOVE NO. 1 EGR COOLER BRACKET

  7. REMOVE HARNESS BRACKET

  8. REMOVE EGR VALVE (ELECTRIC EGR CONTROL VALVE ASSEMBLY)

  9. REMOVE ENGINE OIL LEVEL DIPSTICK

  10. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE

  11. REMOVE INTAKE AIR CONNECTOR WITH DIESEL THROTTLE BODY

  12. REMOVE FUEL INLET PIPE SUB-ASSEMBLY

  13. REMOVE NOZZLE LEAKAGE PIPE SET CLAMP

  14. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY

  15. DISCONNECT NO. 2 FUEL HOSE

    1. A194600

      Disconnect the No. 2 fuel hose from the supply pump assembly.

  16. REMOVE SUPPLY PUMP ASSEMBLY

  17. REMOVE NO. 1 SUPPLY PUMP DRIVE COUPLING

  18. REMOVE NO. 2 OIL COOLER HOSE

  19. REMOVE NO. 4 WATER BY-PASS HOSE

  20. REMOVE WATER BY-PASS PIPE SUB-ASSEMBLY

    1. A250676

      Disconnect the water by-pass hose from the cylinder block assembly.

    2. A250677

      Disconnect the oil cooler hose from the water by-pass pipe sub-assembly.

    3. A245812

      Remove the 2 bolts and water by-pass pipe sub-assembly.

    4. Remove the O-ring from the water by-pass pipe sub-assembly.

  21. REMOVE NO. 2 CYLINDER HEAD COVER

  22. REMOVE CAMSHAFT POSITION SENSOR (w/o Stop And Start System)

    1. A208058

      Remove the bolt and camshaft position sensor.

  23. REMOVE VACUUM PUMP ASSEMBLY

  24. REMOVE V-RIBBED BELT TENSIONER ASSEMBLY

  25. REMOVE HARNESS BRACKET

  26. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

  27. REMOVE ENGINE MOUNTING BRACKET RH

  28. REMOVE NO. 2 TIMING CHAIN COVER

  29. REMOVE CRANKSHAFT DAMPER SUB-ASSEMBLY

  30. DISCONNECT INLET WATER HOSE LH

    1. A250678

      Disconnect the inlet water hose LH from the inlet water housing.

  31. REMOVE TIMING CHAIN COVER SUB-ASSEMBLY

  32. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY

  33. REMOVE CHAIN TENSIONER SLIPPER

  34. REMOVE NO. 1 CHAIN VIBRATION DAMPER

  35. REMOVE CHAIN SUB-ASSEMBLY

  36. REMOVE CAMSHAFT

    1. A200011C06

      *a

      No. 3 Camshaft Bearing Cap

      Remove the 2 bolts from the No. 1 camshaft bearing cap and 8 bolts from the 4 No. 2 camshaft bearing caps by loosening them in the order shown in the illustration, and then remove the No. 1 camshaft bearing cap and 4 No. 2 camshaft bearing caps.

      Note:
      • Using several steps, uniformly loosen the bolts while keeping the camshaft level.

      • Do not remove the No. 3 camshaft bearing cap.

    2. Remove the camshaft from the cylinder head sub-assembly.