COOLING FAN ECU ON-VEHICLE INSPECTION
PROCEDURE
CHECK COOLING FAN SYSTEM
Check and ensure the following conditions:
The ignition switch is off.
The engine coolant temperature is less than 86°C (187°F).
The battery voltage is between 11 to 14 V.
The A/C switch is off.
Connect the pickup of a clamp-on ammeter around either of the 2 wires for the cooling fan motor.
Turn the ignition switch to ON and wait for approximately 10 seconds. Check that the cooling fans are not operating.
Start the engine. Check that the cooling fans are not operating with the engine idling.
Tip:Make sure that the engine coolant temperature is less than 91°C (196°F).
Turn the A/C switch off.
Check that the cooling fans operate when the A/C switch is turned on.
Measure the current while the cooling fan motors are turning.
Standard Current
Item
Condition
Specified Condition
Cooling fan motor
Battery voltage applied at 20°C (68°F)
11.2 to 17.2 A
No. 2 cooling fan motor
11.2 to 17.2 A
Tip:The engine coolant temperature should be less than 91°C (196°F).
Check that the cooling fans operate when the engine coolant temperature sensor connector is disconnected.
Measure the current while the cooling fan motors are turning.
Standard Current
Item
Condition
Specified Condition
Cooling fan motor
Battery voltage applied at 20°C (68°F)
11.2 to 17.2 A
No. 2 cooling fan motor
11.2 to 17.2 A
-
*a
Operating Diagram
*b
Fan Speed
*c
MAX HI
*d
HI
*e
LO
*f
OFF
After the engine is warmed up, check that the cooling fans operate as shown in the illustration.
Tip:The engine coolant temperature at which the fans start operating is approximately 93°C (199°F).
This system can also be checked using the GTS.
Enter the following menus: Powertrain / Engine / Data List / Coolant Temperature
Powertrain > Engine > Data List
Tester Display
Coolant Temperature