COMBUSTION TYPE POWER HEATER SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:
  • Use the following procedure to troubleshoot the combustion type power heater system.

  • *: Use the DTC tester.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT

    NEXT
  2. CUSTOMER PROBLEM ANALYSIS AND SYMPTOM CHECK

    Result

    Proceed to

    NEXT

    NEXT
  3. INSPECT BATTERY VOLTAGE

    1. Inspect the battery voltage.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT

    NEXT
  4. CHECK FOR DTC*

    1. Check for DTCs and note any codes that are output.

    2. Clear the DTCs.

    3. Recheck for DTCs.

      Result

      Result

      Proceed to

      DTCs are not output

      A

      DTCs are output

      B

    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART

    A
  5. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click here

      Result

      Result

      Proceed to

      Fault is not listed in Problem Symptoms Table

      A

      Fault is listed in Problem Symptoms Table

      B

    B

    ADJUST , REPAIR OR REPLACEClick here

    A
  6. OVERALL ANALYSIS AND TROUBLESHOOTING*

    1. Terminals of ECU.

      Click here

    2. Inspection

    Result

    Proceed to

    NEXT

    NEXT
  7. ADJUST , REPAIR OR REPLACE

    Result

    Proceed to

    NEXT

    NEXT

    END