ROAD SIGN ASSIST SYSTEM SYSTEM DESCRIPTION
ROAD SIGN ASSIST SYSTEM DESCRIPTION
The road sign assist system uses the pre-crash safety city sensor to recognize traffic signs and provides information to the driver on the multi-information display.
ROAD SIGN ASSIST SYSTEM CONTROL
Control Pattern 1:
*a
Multi-information Display
*b
Traffic Sign
*c
Distance
-
-
After a sign is recognized by the pre-crash safety city sensor and the vehicle passes by, the sign is displayed on the multi-information display. If no new signs are recognized while a sign is displayed, the system assesses the reliability of the currently displayed sign and clears the display.
Control Pattern 2:
*a
Ignition Switch off
*b
Ignition Switch ON
*c
Multi-information Display
-
-
If a speed limit sign was displayed when the previous trip ended, when the ignition switch is turned to ON, the same sign is displayed again.
Control Pattern 3:
*a
Multi-information Display
*b
Traffic Sign
While a sign is displayed, if the currently traveled road changes due to a left or right turn, etc., the displayed sign is cleared.
DISPLAY SPECIFICATIONS
Road signs recognized by the pre-crash safety city sensor are divided into the following categories and displayed on the multi-information display.
Supported Road Sign
Multi-information Display
Notification Function Operation
Category
Type
Multi-information Display
Buzzer
Speed Limit
Maximum speed limit/End of speed limit

Excess speed notification

(Display inverts)
Sounds*1
No Overtaking
No overtaking/End of no overtaking

No overtaking notification

(Blinks)
Sounds*1
All canceled
(All restrictions canceled. Return to default road regulation.)

-
-
Supplemental Signs (display simultaneously with speed limit)
Rain

-
-
Ice

-
-
Ramp way*2

-
-
Supplemental mark exists
(Contents not recognized)

-
-
*1: Through the customization settings, the buzzer can be made to sound during warnings. However, a buzzer warning will not occur when exceeding the speed limit with a supplemental sign present.
*2: This sign is not displayed when performing a lane change without operating the turn signal.
The display format for signs displayed on the multi-information display can be changed using the steering pad switch assembly.