CYLINDER HEAD REASSEMBLY

PROCEDURE

  1. INSTALL NO. 1 WATER BY-PASS PIPE

    A203751N01
    Tip:

    When using a new cylinder head sub-assembly, a new No. 1 water by-pass pipe must be installed.

    1. Apply adhesive to a new No. 1 water by-pass pipe.

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    2. Install the No. 1 water by-pass pipe as shown in the illustration.

  2. INSTALL WATER OUTLET

    A203748N01
    Tip:

    When using a new cylinder head sub-assembly, a new water outlet must be installed.

    1. Apply adhesive to a new water outlet.

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    2. Install the water outlet.

      Standard Protrusion

      79 to 85 mm (3.11 to 3.35 in.)

      Standard Angle

      51 to 61°

  3. INSTALL ELBOW

    A203747N01
    Tip:

    When using a new cylinder head sub-assembly, a new elbow must be installed.

    1. Apply adhesive to a new elbow.

      Adhesive

      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

    2. Install the elbow.

      Standard Protrusion

      56.5 to 62.5 mm (2.22 to 2.46 in.)

      Standard Angle

      20 to 30°

  4. INSTALL VALVE SPRING SEAT PLATE WASHER

    1. Install the valve spring seat plate washer to the cylinder head sub-assembly.

  5. INSTALL VALVE STEM OIL SEAL

    1. Apply a light coat of engine oil to a new valve stem oil seal.

    2. A111374C01

      *1

      Valve Stem Oil Seal

      Using SST, push in the valve stem oil seal.

      09201-41020

      Note:

      Failure to use SST will cause the valve stem oil seal to be damaged or improperly seated.

  6. INSTALL INTAKE VALVE

    1. A101416N04

      Apply plenty of engine oil to the tip area of the intake valve shown in the illustration.

    2. Place the cylinder head sub-assembly on a wooden block.

    3. Install the intake valve, inner compression spring and valve spring retainer to the cylinder head sub-assembly.

      Note:

      Install the same parts in the same combination to their original locations.

    4. A111290N02

      Using SST, compress the inner compression spring and place the intake valve spring retainer locks around the intake valve stem.

      09202-70020

    5. A111375

      Using a 5 mm pin punch and plastic hammer, lightly tap the intake valve stem tip to ensure a proper fit.

      Note:

      Be careful not to damage the intake valve stem tip.

  7. INSTALL EXHAUST VALVE

    1. A101419N04

      Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.

    2. Place the cylinder head sub-assembly on a wooden block.

    3. Install the exhaust valve, inner compression spring and exhaust valve spring retainer to the cylinder head sub-assembly.

      Note:

      Install the same parts in the same combination to their original locations.

    4. A111289N02

      Using SST, compress the inner compression spring and place the exhaust valve spring retainer locks around the exhaust valve stem.

      09202-70020

    5. A111376

      Using a 5 mm pin punch and plastic hammer, lightly tap the exhaust valve stem tip to ensure a proper fit.

      Note:

      Be careful not to damage the exhaust valve stem tip.