SFI SYSTEM Turbocharger Noise

DTC Code DTC Name
Turbocharger Noise

DESCRIPTION

Tip:

Turbocharger noise is classified into two types. These are whistling sound and chattering sound. During troubleshooting, first determine the type of noise.

Type of Abnormal Noise

Outline of Abnormal Noise

Major Trouble Area

Whistling sound (airflow sound)

The whistling sound volume and pitch are proportional to the turbocharger or engine speed. The abnormal noise level becomes clear when the engine speed is increased.

  • Turbocharger (example: unstable shaft)

  • Transmission gears

  • Leak in intake system

  • Damaged intake system

Chattering sound (metallic sound)

The chattering sound pitch is lower than the whistling sound pitch. Has a comparatively constant pitch that is independent of the engine speed and vehicle speed.

Turbocharger

Tip:
  • The turbocharger vibrations are transmitted to the exhaust pipe, causing noise and resonance.

  • The turbocharger vibrations are transmitted through the exhaust pipe to the chassis (floor), causing noise and resonance in the chassis.

  1. Faults and Symptoms of Gasoline Engine Components

Table 1. Turbocharger system

Main fault

  • Unstable turbocharger turbine shaft (interference, seizing, poor balance, etc.)

  • Poor installation or defective operation of the waste gate valve.

  • Poor installation or defective operation of the air by-pass valve assembly.

Symptom

  • High-pitched whistling sound

    Tip:

    The volume and pitch are proportional to the turbocharger speed.

  • Metallic sound due to looseness

Table 2. Intake system

Main fault

Leak

Symptom

Abnormal noise during intake leak

Table 3. Transmission gears

Symptom

Gear noise

Tip:

The volume and pitch are proportional to the transmission gear speed.

PROCEDURE

  1. CONFIRM CONDITION IN WHICH NOISE OCCURRED

    1. Confirm with the customer the condition when noise occurred.

      Tip:

      To clearly understand the conditions in which the noise occurred, the items in the table below are useful.

      Item

      Note

      Engine speed

      Engine speed range

      Vehicle speed

      Vehicle speed range

      Transaxle gear

      Which gear?

      Accelerator pedal position

      During acceleration or deceleration?

      Temperature

      • Ambient temperature

      • Engine temperature (cold, warmed up, etc.)

      Road conditions

      • City or highway driving

      • Uphill or downhill

      Noise level

      • Did the noise occur suddenly, or build gradually?

      • Has the noise gradually been getting louder?

      Other symptoms

      • Lack of power

      • High fuel consumption, etc.

      Noise recognition

      What made the customer determine that the sound was a malfunction?

    Result

    Proceed to

    NEXT

    NEXT
  2. CHECK DTC OUTPUT

    1. Connect the GTS to the DLC3.

    2. Start the engine.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine / Trouble Codes.

    5. Check DTCs.

      Powertrain > Engine > Trouble Codes

      Result

      Result

      Proceed to

      DTCs are not output

      A

      DTCs are output

      B

      Tip:
      • Check whether DTCs related to the turbo pressure sensor or atmospheric pressure sensor are output.

      • If a DTC related to the turbo pressure sensor or atmospheric pressure sensor is output, defective actuator control related to the turbocharger may be the cause of the noise.

    B

    GO TO DTC CHART

    A
  3. PERFORM SIMULATION TEST

    1. Check whether the noise described by the customer occurs.

      Tip:

      If an abnormal noise is heard, check whether it matches the noise described by the customer.

    2. If an abnormal noise is confirmed, determine which system emits it.

    Result

    Result

    Proceed to

    Noise occurs (ticking or rattling (metallic sound) during idling)

    A

    Noise occurs (squealing (metallic sound) when driving)

    B

    Noise occurs (hissing (airflow sound) when driving)

    C

    Noise occurs (squeaking or chuffing (airflow sound) during deceleration)

    D

    Noise occurs (whistling or foghorn-like (airflow sound) during acceleration)

    E

    Noise occurs (whistling (airflow sound) during deceleration)

    F

    The noise described by the customer could not be confirmed.

    G

    B

    CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT TURBINE SHAFT)Click here

    C

    CHECK TURBOCHARGER SUB-ASSEMBLYClick here

    D

    CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT AIR BY-PASS VALVE)Click here

    E

    REPLACE TURBOCHARGER SUB-ASSEMBLYClick here

    F

    CHECK GEAR NOISEClick here

    G

    EXPLAIN TO CUSTOMER THAT SOUND IS NORMALClick here

    A
  4. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT WASTE GATE VALVE ACTUATOR AND ACTUATOR ROD)

    1. Check the installation condition of the E-ring on the link connection of the waste gate valve actuator and turbine housing.

    2. Check the actuator rod for the waste gate valve actuator.

      Tip:
      • Actuator rod wear may cause looseness leading to a chattering sound (metallic sound).

      • Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the operation sound.

    Result

    Result

    Proceed to

    No actuator rod malfunction

    A

    Actuator rod malfunction

    B

    B

    REPLACE TURBOCHARGER SUB-ASSEMBLY (WASTE GATE VALVE ACTUATOR OR ACTUATOR ROD MALFUNCTION)

    A
  5. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT COMPRESSOR IMPELLER AND COMPRESSOR HOUSING)

    1. Check for damage to the compressor impeller.

    2. Check for interference between the compressor impeller and the compressor housing.

    Result

    Result

    Proceed to

    No damage or interference

    A

    Damage or interference exists

    B

    A

    END (CAUSE CHECK EXCEPT THE TURBOCHARGER)

    B

    REPLACE TURBOCHARGER SUB-ASSEMBLY (COMPRESSOR IMPELLER OR COMPRESSOR HOUSING MALFUNCTION)

  6. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT TURBINE SHAFT)

    1. Check that the turbine shaft rotates smoothly, without catching.

      Click here

    2. Check for loose turbine mounting nuts and for axial play in the turbine shaft.

      Click here

      Tip:

      If the turbine shaft catches or there is no play, seal failure due to seizure or improper operation due to accumulation of deposits is suspected.

    Result

    Result

    Proceed to

    No turbine shaft malfunction

    A

    Turbine shaft malfunction

    B

    B

    REPLACE TURBOCHARGER SUB-ASSEMBLY (TURBINE SHAFT MALFUNCTION)

    A
  7. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT COMPRESSOR IMPELLER AND COMPRESSOR HOUSING)

    1. Check for damage to the compressor impeller.

    2. Check for interference between the compressor impeller and the compressor housing.

    Result

    Result

    Proceed to

    No damage or interference

    A

    Damage or interference exists

    B

    B

    REPLACE TURBOCHARGER SUB-ASSEMBLY (COMPRESSOR IMPELLER OR COMPRESSOR HOUSING MALFUNCTION)

    A
  8. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT AIR BY-PASS VALVE)

    1. Inspect the air by-pass valve assembly.

      Click here

    Tip:
    • The abnormal noise may be caused by defective operation of the air by-pass valve assembly.

    • If the previous checks find no malfunction, replace the turbocharger sub-assembly and determine if the noise improved.

    Result

    Proceed to

    OK

    NG

    NG

    REPLACE TURBOCHARGER SUB-ASSEMBLY (AIR BY-PASS VALVE MALFUNCTION)

    OK
  9. REPLACE TURBOCHARGER SUB-ASSEMBLY

    1. Replace the turbocharger sub-assembly.

      Click here

    Result

    Proceed to

    NEXT

    NEXT
  10. PERFORM SIMULATION TEST

    1. Check that the abnormal noise has disappeared.

    Result

    Proceed to

    NEXT

    NEXT

    END

  11. CHECK TURBOCHARGER SUB-ASSEMBLY

    1. Check for oil leaks and large carbon deposits around the connecting surfaces of the turbocharger sub-assembly.

      A425209E01
      Tip:

      If oil leaks or a large amount of carbon deposits exist, air leaks from the respective sealing surfaces may be causing the noise.

    Result

    Result

    Proceed to

    An oil leak or large amount of carbon deposits does not exist.

    A

    A large amount of carbon deposits exist around the turbine housing, flange or gaskets in any of the areas (A) shown in the illustration.

    B

    Oil is leaking from between the sealing surfaces of the seal plate and compressor housing or bearing housing in the area (B) shown in the illustration.

    C

    Oil is leaking from the compressor housing in any of the areas (C) shown in the illustration.

    D

    B

    CHECK EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLYClick here

    C

    REPLACE TURBOCHARGER SUB-ASSEMBLY

    D

    CHECK AND REPAIR AIR TUBE OR HOSE CLAMP

    A
  12. REPLACE TURBOCHARGER SUB-ASSEMBLY

    1. Replace the turbocharger sub-assembly.

      Click here

      Tip:

      As the waste gate valve actuator or air by-pass valve is malfunctioning, it is necessary to replace the turbocharger sub-assembly.

    Result

    Proceed to

    NEXT

    NEXT
  13. PERFORM SIMULATION TEST

    1. Check that the abnormal noise has disappeared.

    Result

    Proceed to

    NEXT

    NEXT

    END

  14. CHECK EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    1. Check for deformation or cracks in the mounting surfaces on the exhaust manifold converter sub-assembly and the turbine housing.

      Tip:

      Deformation or cracks on a mounting surface may allow exhaust gas to leak from the damaged position.

      Standard

      No deformation or cracks on a mounting surface

      Result

      Result

      Proceed to

      No problem with the mounting surface

      A

      Deformation or cracks on the exhaust manifold converter sub-assembly mounting surface

      B

      Deformation or cracks on the turbine housing mounting surface

      C

    B

    REPLACE EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY

    C

    REPLACE TURBOCHARGER SUB-ASSEMBLY

    A
  15. REPLACE GASKET

    1. Replace the exhaust gasket.

    Result

    Proceed to

    NEXT

    NEXT
  16. PERFORM SIMULATION TEST

    1. Check that the abnormal noise has disappeared.

    Result

    Proceed to

    NEXT

    NEXT

    END

  17. CHECK TURBOCHARGER SUB-ASSEMBLY (INSPECT AIR BY-PASS VALVE)

    1. Inspect the air by-pass valve assembly.

      Click here

      Tip:

      The abnormal noise may be caused by defective operation of the air by-pass valve assembly.

    Result

    Proceed to

    OK

    NG

    NG

    REPLACE TURBOCHARGER SUB-ASSEMBLY (AIR BY-PASS VALVE MALFUNCTION)

    OK
  18. READ VALUE USING GTS (ATMOSPHERIC PRESSURE)

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Enter the following menus: Powertrain / Engine / Data List / Atmospheric Pressure.

      Powertrain > Engine > Data List

      Tester Display

      Atmospheric Pressure

    4. Using the table, read the normal atmospheric pressure value for the applicable altitude and temperature.

      A337505
      Tip:
      • Standard atmospheric pressure is approximately 101 kPa(abs) (15 psi(abs)).

      • For every 100 m (328 ft.) increase in altitude, atmospheric pressure drops by approximately 1 kPa (0.15 psi). This varies by weather.

    5. Compare the Atmospheric pressure value in the Data List with the normal atmospheric value from the table.

      Result

      Result

      Proceed to

      Other than the following

      A

      Difference between Atmospheric Pressure in the Data List and normal atmospheric pressure value is 10 kPa (1.45 psi) or more.

      B

    B

    REPLACE ECM

    A
  19. CHECK NO. 1 TURBO PRESSURE SENSOR

    1. On-vehicle inspect the No. 1 turbo pressure sensor.

      Click here

    Result

    Proceed to

    OK

    NG

    OK

    REPLACE ECM

    NG

    REPLACE NO. 1 TURBO PRESSURE SENSOR

  20. REPLACE TURBOCHARGER SUB-ASSEMBLY

    1. Replace the turbocharger sub-assembly.

      Click here

      Tip:

      As the turbine shaft play is not appropriate or the compressor impeller is malfunctioning, it is necessary to replace the turbocharger sub-assembly.

    Result

    Proceed to

    NEXT

    NEXT
  21. PERFORM SIMULATION TEST

    1. Check that the abnormal noise has disappeared.

    Result

    Proceed to

    NEXT

    NEXT

    END

  22. CHECK GEAR NOISE

    1. Check if gear noise is the source of the abnormal noise (not noise from the turbocharger).

      Result

      Proceed to

      NEXT

    NEXT

    ELIMINATE THE CAUSE OF THE NOISE

  23. EXPLAIN TO CUSTOMER THAT SOUND IS NORMAL

    1. Explain to the customer that the sound described by the customer is not a malfunction.

      Tip:

      To convince the customer, it is helpful to drive the customer in a different vehicle.

    Result

    Proceed to

    NEXT

    NEXT

    END