DIESEL THROTTLE BODY REMOVAL
PROCEDURE
REMOVE NO. 1 ENGINE UNDER COVER
w/ Glow Plug Controller:
-
for Full Cover Type:
for Half Cover Type:
w/o Glow Plug Controller:
-
for Full Cover Type:
for Half Cover Type:
REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)
w/ Glow Plug Controller:
w/o Glow Plug Controller:
REMOVE INTERCOOLER AIR HOSE
w/ Glow Plug Controller:
w/o Glow Plug Controller:
REMOVE NO. 2 AIR TUBE
-
*a
Intake Air Temperature Sensor Connector
Disconnect the intake air temperature sensor connector.
Remove the 2 bolts.
Loosen the 2 hose clamps and remove the No. 2 air tube.
-
REMOVE DIESEL THROTTLE BODY ASSEMBLY (w/ Glow Plug Controller)
-
*a
Generator Assembly Connector
*b
Diesel Throttle Body Assembly Connector
Disconnect the generator assembly connector and diesel throttle body assembly connector.
-
Remove the bolt.
Disengage the clamp to separate the engine wire.
-
*1
No. 3 Water By-pass Hose
*2
No. 5 Water By-pass Hose
Slide the 2 clips and disconnect the No. 3 water by-pass hose and No. 5 water by-pass hose from the diesel throttle body assembly.
-
Remove the 4 bolts, diesel throttle body assembly and venturi gasket from the intake air connector.
Note:If the diesel throttle body assembly has been struck or dropped, replace it.
-
REMOVE DIESEL THROTTLE BODY ASSEMBLY (w/o Glow Plug Controller)
-
*a
Generator Assembly Connector
*b
Diesel Throttle Body Assembly Connector
Disconnect the generator assembly connector and diesel throttle body assembly connector.
-
Remove the nut.
Disengage the clamp and separate the engine wire.
-
Remove the 4 bolts, diesel throttle body assembly, venturi gasket and wire harness bracket from the intake air connector.
Note:If the diesel throttle body assembly has been struck or dropped, replace it.
-