OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

    1. A304094C10

      *a

      Adhesive 1344

      *b

      Oil Inlet Port

      Apply adhesive to 2 or 3 threads of the oil pressure sender gauge assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note:
      • Do not apply adhesive to the oil inlet port of the oil pressure sender gauge assembly.

      • Install the oil pressure sender gauge assembly within 3 minutes of applying adhesive.

    2. Using a 27 mm deep socket wrench, install the oil pressure sender gauge assembly.

      15 N*m

      153 kgf*cm

      11 ft.*lbf

    3. Connect the oil pressure sender gauge assembly connector.

  2. INSPECT FOR ENGINE OIL LEAK