CAMSHAFT POSITION SENSOR REMOVAL

PROCEDURE

  1. REMOVE NO. 2 CYLINDER HEAD COVER

  2. REMOVE NO. 1 CRANK POSITION SENSOR

    1. for Exhaust side:

      1. A205040

        Disconnect the No. 1 crank position sensor connector.

      2. Remove the bolt and No. 1 crank position sensor from the cylinder head cover sub-assembly.

        Note:

        If a component has been dropped or subjected to a strong impact, replace it.

    2. for Intake side:

      1. A282701

        Disconnect the No. 1 crank position sensor connector.

      2. Remove the bolt and No. 1 crank position sensor from the cylinder head cover sub-assembly.

        Note:

        If a component has been dropped or subjected to a strong impact, replace it.