KNOCK SENSOR INSTALLATION

PROCEDURE

  1. INSTALL KNOCK SENSOR

    1. A197597C01

      *a

      Up

      Install the knock sensor to the cylinder block with the bolt as shown in the illustration.

      20 N*m

      204 kgf*cm

      15 ft.*lbf

      Note:
      • If a component has been dropped or subjected to a strong impact, replace it.

      • Make sure that the knock sensor is in the correct position.

      Tip:

      Perform "Inspection After Repairs" after replacing the knock sensor (Click here).

    2. Connect the knock sensor connector.

  2. INSTALL INTAKE MANIFOLD