THERMOSTAT REMOVAL
PROCEDURE
DRAIN ENGINE COOLANT
REMOVE GENERATOR ASSEMBLY (for 80A Type)
REMOVE GENERATOR ASSEMBLY (for 100A Type)
REMOVE OIL LEVEL DIPSTICK GUIDE SUB-ASSEMBLY
DISCONNECT NO. 1 WATER BY-PASS PIPE
-
Slide the clip and disconnect the No. 1 water by-pass pipe.
Remove the bolt and No. 1 water by-pass pipe.
-
DISCONNECT NO. 2 RADIATOR HOSE
-
Slide the clip and disconnect the No. 2 radiator hose from the water inlet.
-
REMOVE WATER INLET
-
Remove the 3 bolts and water inlet.
-
REMOVE NO. 2 WATER INLET HOUSING GASKET
-
*1
No. 2 Water Inlet Housing Gasket
Remove the No. 2 water inlet housing gasket from the water inlet.
-
REMOVE THERMOSTAT
-
*1
Frame
Remove the frame from the water inlet.
Tip:Using needle nose pliers, push down on the frame to compress the spring. While the spring is compressed, turn the frame to remove it from the water inlet.
Remove the spring and element.
-