SPEED LIMITER SYSTEM DATA LIST / ACTIVE TEST
DATA LIST
Tip:Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Note:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Cruise Control / Data List.
Read the Data List according to the display on the GTS.
Powertrain > Cruise Control > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
ASL Vehicle Speed
Vehicle speed
Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph)
Actual vehicle speed displayed
-
ASL Memory Vehicle Speed
Vehicle speed
Min.: 0 km/h (0 mph), Max.: 255 km/h (159 mph)
Vehicle speed stored in memory
-
ASL Throttle Position
Throttle opening angle
Min.: 0 deg., Max.: 124.5 deg
Required throttle opening angle
-
ASL Ready
Speed limit standby condition
ON or OFF
OFF: Speed limiter switch off
ON: Speed limiter switch on
-
ASL Main Switch
Speed limiter switch signal
ON or OFF
OFF: Speed limiter switch off
ON: Speed limiter switch on
-
ASL Shift Position Request
Transaxle gear request signal
Min.: 0, Max.: 8
Required transaxle gear
-
Tip:ASL Shift Position Request: for CVT
ACTIVE TEST
Tip:Using the GTS to perform Active Tests allows relays, VSVs, actuators and other item to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body / Combination Meter / Active Test.
Perform "Active Test" according to the display on GTS.
Body Electrical > Combination Meter > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
Indicat. ASL
Speed limiter indicator
ON / OFF
-