EXHAUST FUEL ADDITION INJECTOR INSTALLATION

PROCEDURE

  1. INSTALL FUEL INJECTOR SEAL

    1. Install a new fuel injector seal to the exhaust fuel addition injector assembly.

  2. INSTALL EXHAUST FUEL ADDITION INJECTOR ASSEMBLY

    Note:

    If there is any foreign matter on the installation surface of the exhaust fuel addition injector assembly, be sure to clean the exhaust fuel addition injector assembly before installation.

    1. Install a new gasket, the exhaust fuel addition injector assembly, nozzle holder clamp and washer with the bolt.

      29 N*m

      296 kgf*cm

      21 ft.*lbf

      A201785C01

      *1

      Nozzle Holder Clamp

      Tip:

      Align the nozzle holder clamp with the cutouts of the exhaust fuel addition injector assembly as shown in the illustration.

  3. INSTALL FUEL TUBE SUB-ASSEMBLY

  4. INSTALL FUEL HOSE PROTECTOR

    1. Install the fuel hose protector with the bolt.

      20.5 N*m

      209 kgf*cm

      15 ft.*lbf

  5. INSTALL WIRE HARNESS CLAMP BRACKET

    1. Install the wire harness clamp bracket with the bolt.

      21 N*m

      214 kgf*cm

      15 ft.*lbf

  6. CONNECT WIRE HARNESS

    1. Install the bolt to the fuel hose protector.

      12.5 N*m

      127 kgf*cm

      9 ft.*lbf

    2. Connect the 5 connectors and 3 wire harness clamps.

  7. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

  8. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

  9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  10. INSPECT FOR FUEL LEAK

  11. INSTALL NO. 1 ENGINE COVER