CLUTCH SYSTEM(for EC65A) PRECAUTION
PRECAUTION REGARDING ON-VEHICLE INSPECTION
When racing the engine, make sure that the gear is in neutral.
PRECAUTION REGARDING PARTS INSTALLATION
When installing parts related to the multi-mode manual transmission system, perform Clamp Position Adjustment, Initialization and Learning and/or Synchronization Position Calibration. In addition, the required operations differ according to the parts to be installed. Proceed with the operation in the order shown in the table below.
Table 1. After Installation Parts Installed
Operation Order
See Procedure
Transmission assembly
Transmission parts (inside gear box)
TCM
Clutch actuator
Clutch disc and clutch cover
Clutch release with bearing cylinder assembly
Flywheel
Crankshaft
Clutch fluid
1. Initialization of multi-mode manual transmission system
[Initialization of ECU]
2. Learning of multi-mode manual transmission system
3. Synchronization position calibration
Shift and select actuator
Shift stroke sensor
Select stroke sensor
1. Initialization of multi-mode manual transmission system
[Initialization of transmission]
2. Learning of multi-mode manual transmission system
3. Synchronization position calibration
Clutch stroke sensor
1. Initialization of multi-mode manual transmission system
[Initialization of clutch]
2. Learning of multi-mode manual transmission system
Note:After replacing any system components, perform initialization and learning of related components (refer to the operations listed above). If initialization and learning are not performed, the transmission system will not function properly.
Before proceeding with learning of the multi-mode manual transmission system, clear (initialize) the previously stored learned values. Since the multi-mode manual transmission system does not have an overwrite function, clearing (initializing) stored data is necessary to perform learning of the system.