REAR DOOR COURTESY SWITCH(for Sedan) INSTALLATION

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

    1. Using a T30 "TORX" socket wrench, install the rear door courtesy light switch assembly with the screw.

      6.3 N*m

      64 kgf*cm

      56 in.*lbf

      Tip:

      There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

    2. Connect the connector.

  2. INSTALL REAR SEAT SIDE GARNISH

  3. INSTALL REAR SEATBACK HINGE SUB-ASSEMBLY

  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

  5. INSTALL REAR DOOR SCUFF PLATE

  6. INSTALL REAR SEATBACK ASSEMBLY LH (for LH Side)

  7. INSTALL REAR SEATBACK ASSEMBLY RH (for RH Side)

  8. INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)

  9. INSTALL REAR SEAT HEADREST ASSEMBLY

  10. INSTALL REAR SEAT CUSHION ASSEMBLY

  11. INSTALL SPARE WHEEL COVER